Engine Department Competence

Slow Speed Engine – Operational Level (Junior Engineer)

Test designed for junior engineers working with two-stroke slow-speed main engines (e.g., MAN B&W, Wärtsilä RT-flex). Covers starting and control systems, fuel injection, cylinder lubrication, scavenge air system, cooling, and safety procedures.

प्रश्न 60

समय सीमा 59 min

भाषा अंग्रेज़ी

नमूना प्रश्न

यहाँ इस क्विज़ के कुछ उदाहरण प्रश्न हैं। पूरा टेस्ट देने के लिए GYRO ऐप डाउनलोड करें।

प्रश्न 1

The PTT-switch must be:

A Pressed in during speaking only to work duplex.

B Pressed in constantly to work simplex.

C Pressed in during speaking only to work semi-duplex.

D Pressed to listen.

प्रश्न 2

How does the International Regulations for Preventing Collisions define a "vessel restricted in her ability to manoeuvre"?

A A vessel which because of her draught in relation to the available depth of water is restricted in her ability to deviate from her course and keep out of the way of another vessel.

B A vessel which from the nature of her work is restricted in her ability to manoeuvre as required by the Rules and cannot keep out of the way of another vessel.

C A vessel engaged in underwater work, such as laying, servicing a pipeline, diving support, dredging, mine-clearance, or pilot deployment/recovery.

D A vessel which through some exceptional circumstance is unable to manoeuvre as required by the Rules and cannot keep out of the way of another vessel.

प्रश्न 3

Which one of the listed requirements regarding the stowage of rescue boats corresponds to present SOLAS regulations. Rescue boats shall be stowed:

A Wherever space is available.

B So that neither the rescue boat nor its launching arrangements will interfere with any survival craft at any other launching station.

C Attached to launching appliances.

D In a state of readiness for launching in not more than two minutes.

प्रश्न 4

Which position is the best to stop bleeding from the nose?

A Laying on the back, leaning the head as much back as possible.

B Holding the nose above steamed water.

C Laying on the back, holding a wet, cold towel on the top of the nose.

D Sitting on a chair, leaning forward, with two fingers pressing the nose together.

प्रश्न 5

Why is the set value of the turn radius important in route creation on an ECDIS?

A Because at waypoints the wheel over position is established from it.

B Turn radius allows ETAs to be worked from it.

C It is not important as the Master always changes course their way.

D Because the value should be on the passage plan.

Slow Speed Engine – Operational Level (Junior Engineer)

यह क्विज़ दें. इस क्विज़ को देने और अपनी प्रगति ट्रैक करने के लिए GYRO ऐप डाउनलोड करें।